The occupant detection system sensor is installed under the seat upholstery and monitors the physique and posture of the front passenger. Using this information, the occupant detection system determines whether the front passenger's SRS frontal airbag should be deployed or not.
If the front passenger's seat cushion is wet, this may adversely affect the ability of the system to determine deployment. If the seat cushion is wet, the front passenger should stop sitting on the front passenger's seat. Wipe off liquid from the seat immediately, let the seat dry naturally and then check the SRS airbag system warning light as follows.
SRS airbag system warning light (type A)
SRS airbag system warning light (type B)
Front passenger's frontal airbag ON indicator
Front passenger's frontal airbag OFF indicator
Also, if luggage or electronic devices are placed on the front passenger's seat, this may adversely affect the ability of the system to determine deployment. This may prevent the front passenger's frontal airbag ON and OFF indicators from working properly. Check that the indicators work properly.
When the OFF indicator turns off and the ON indicator illuminates, the front passenger's frontal airbag may deploy during a collision. Remove luggage and electronic devices from the front passenger's seat.
CAUTION
Electrical devices, such as cell phones, laptops, portable music players, or electronic games, especially when connected to the accessory power outlet and placed on the front passenger's seat or used by the person sitting in the front passenger's seat, may affect the operation of the occupant detection system.
If either of the following situations occurs when using an electronic device in the vehicle, at first try to relocate that device to avoid it creating any interference.
If the device continues to cause interference, the use of that device in the vehicle should be discontinued.
NOTE
This device complies with Part 18 of the FCC Rules. This device may cause interference. If this device causes interference, consult the nearest SUBARU dealer. Also, for maintenance of the system, consult the nearest SUBARU dealer. This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45-30 MHz.
Sound settings
Touch the tab to set the
sound quality.
Item
Function
Balance/
Fader
Select to adjust speaker volume
balance (right/left and front/rear).
Speed Volume
Control
Select to adjust speaker volume
coupled to vehicle speed.
Graphic
Equa ...
Front seatbelts
1. Adjust the seat position according to
the following procedure.
Driver's seat: Adjust the seatback to the
upright position. Move the seat as far from
the steering wheel as practical while still
maintaining full vehicle control.
Front passenger's seat: Adjust the seatback
to the upright ...
Inspection
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSPECTION1. Moving the front tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the hub unit bearing.2. Inspect ...