LIGHTING SYSTEM > Turn Signal Light and Hazard Light System
NOTE
For operation procedures of each component of the turn signal and hazard light system, refer to the respective sections.
• Combination switch (light): Combination Switch (Light)">
• Front turn signal light bulb: Front Turn Signal Light Bulb">
• Side turn signal light assembly: Side Turn Signal Light Assembly">
• Rear combination light assembly: Rear Combination Light Assembly">
• Rear turn signal light bulb: Rear Turn Signal Light Bulb">
• Hazard switch: Hazard Switch">
• Turn signal & hazard unit: Turn Signal Light & Hazard Light Unit">
Removal
SECURITY AND LOCKS > Rear Inner RemoteREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. Remove the screw, and remove the remote assembly - door. ...
Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR CoolerREMOVAL1. Disconnect the ground cable from battery.2. Drain engine coolant. Engine Coolant > REPLACEMENT">3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">4. Lower the vehicle.5. Remove the ...
Assembly
WIPER AND WASHER SYSTEMS > Wiper BladeASSEMBLY1. FRONT1. Insert the rubber assembly - windshield wiper onto the blade - windshield wiper so that the stopper is in the position shown in the figure.2. Make sure the rubber assembly - windshield wiper is securely fastened to the pull stopper (a).2. R ...