Subaru Crosstrek Service Manual: Installation

Subaru Crosstrek Service Manual / Hvac system (heater, ventilator and a/c) / In-vehicle sensor (auto a/c model) / Installation

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > In-Vehicle Sensor (Auto A/C Model)

INSTALLATION

Install each part in the reverse order of removal.

Removal

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > In-Vehicle Sensor (Auto A/C Model)REMOVALCAUTION:Be careful not to damage the sensors and interior trims when removing.1. Disconnect the battery ground ca ...

Mode door actuator

...

Other materials:

Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the ...

Inspection
COMMUNICATION SYSTEM > Horn SwitchINSPECTION1. CHECK HORN SWITCHCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Turn the ignition switch to OFF.2 ...

Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyASSEMBLY1. Install the sleeve and the gear and hub assembly by matching the alignment marks.NOTE:• Make sure that there is no large clearance at both sides of the 1st-2nd shifting insert after assembly.(A)1st-2nd shiftin ...