SECURITY AND LOCKS > Keyless Entry Control Module
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">
3. Remove the keyless entry control module.
(1) Disconnect the connector.
(2) Remove the bolt and then remove the keyless entry control module.
Electrical component location Location
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Steering gearbox(3)STEERING warning light(5)VDCCM&H/U(2)Power steering control module(4)Engine control module (ECM)(6)Data link connector (for Subaru Select Monitor)• U5 and U6 models• C ...
Dtc b2815 power supply high voltage
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2815 POWER SUPPLY HIGH VOLTAGEDetected when the status for the battery voltage of 16 V or more continues approximately for 5 seconds and is judged to be abnormally high voltage.Refer to DTC B2814 for DTC detectin ...
Engine oil consumption
Some engine oil will be consumed while
driving. The rate of consumption can be
affected by such factors as transmission
type, driving style, terrain and temperature.
Under the following conditions, oil
consumption can be increased and thus
require refilling between maintenance
intervals:
...