Subaru Crosstrek Service Manual: Removal

NOTE:

Refer to keyless transmitter for model without keyless access with push button start. Keyless Transmitter > REMOVAL">

To prevent static electricity damage to the access key printed circuit board, touch the steel area of building with hand to discharge static electricity carried on body or clothes before disassembling the access key.

1. Push the lock button and remove the mechanical key from the access key.

2. Insert a flat tip screwdriver end wrapped with insulating tape etc. into the slit (a) of the access key to open the case.

3. Insert a flat tip screwdriver wrapped with insulating tape, and while holding the upper side of the battery (a), remove the battery (a) from the case.

Installation

Accessory relay (push button start)

Other materials:

Removal
CONTROL SYSTEMS > AT Shift Lock Solenoid and “P” Range SwitchREMOVAL1. SOLENOID UNIT1. Remove the AT select lever. Select Lever > REMOVAL">2. Remove the spacer and gasket. Select Lever > DISASSEMBLY">3. Using a flat tip screwdriver with a thin tip, remove the h ...

Inspection
LIGHTING SYSTEM > Headlight BulbINSPECTION1. HALOGEN TYPECAUTION:• Do not perform work with wet hands, because there is a possibility of electrical shock.• Do not leave the light assembly - head without the bulb and cover - headlight for a long time. Dust, moisture, etc. entering the ...

Function settings
A SUBARU dealer can change the settings of the functions shown in the following table to meet your personal requirements. Contact the nearest SUBARU dealer for details. If your vehicle is equipped with a multi function display, the settings for some of these functions can be changed using the ...