Subaru Crosstrek Service Manual: Removal

1. RADIO/TELEMATICS ANTENNA

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the trim panel - roof assembly. Roof Trim > REMOVAL">

3. Remove the antenna assembly - radio or telematics.

(1) Disconnect the connector and terminal, and remove the mounting nut (A).

(2) Pull out the antenna assembly - radio or telematics from the roof panel top.

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the trim panel - roof assembly. Roof Trim > REMOVAL">

3. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL">

4. Remove the glove box. Glove Box > REMOVAL">

5. Remove the center grille assembly. Air Vent Grille > REMOVAL">

6. Remove the audio assembly or navigation assembly. Audio > REMOVAL">

7. Turn over the floor mat. Floor Mat > REMOVAL">

8. Remove the cord assembly - antenna feeder.

Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”.

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL">

3. Remove the glove box. Glove Box > REMOVAL">

4. Remove the center grille assembly. Air Vent Grille > REMOVAL">

5. Remove the audio assembly or navigation assembly. Audio > REMOVAL">

NOTE:

The data communication module will be removed at the same time.

6. Remove the combination meter assembly. Combination Meter > REMOVAL">

7. Remove the GPS antenna.

NOTE:

Remove the antenna only. Do not pull the cord.

8. Remove the telematics sub antenna.

(1) Disconnect the telematics sub antenna connector on the data communication module side, and tie a string to the connector.

NOTE:

A string makes operation easier during installation.

(2) Remove the screw and harness clamp, and pull out the telematics sub antenna from the combination meter side.

(3) After the telematics sub antenna has been pulled out, remove the string attached to the connector in step (1).

Installation

Audio

Other materials:

Dtc u0101 lost communication with tcm
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

Pandora(if equipped)
Pandora is an application for a smartphone. This can automatically select and play recommended tracks. By rating the track currently playing, tracks that better match your preference will be recommended. In order to connect to this system, use a USB port for an iPhone or iPod touch and ...

Dtc p0345 camshaft position sensor "a" circuit bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0345 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 2DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine stall• Failure of engine to startCAUTION:After servicing ...