Subaru Crosstrek Service Manual: Installation
EXHAUST(H4DO) > Rear Exhaust Pipe
INSTALLATION
1. Apply a coat of spray type lubricant to the mating area of cushion rubber.
2. Install the rear exhaust pipe to cushion rubber.
NOTE:
After assembling, degrease the lubricant which was applied to the cushion rubber while removing/installing.
3. Install the bolts and self-locking nuts which secure the muffler to the rear exhaust pipe.
NOTE:
Use a new gasket and self-locking nut.
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
4. Install the bolts, springs, and nuts which secure the center exhaust pipe to the rear exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
5. Lower the vehicle.
Removal
EXHAUST(H4DO) > Rear Exhaust PipeREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Turn the ignition switch to OFF.2. Lift up the ve ...
Other materials:
Removal
INSTRUMENTATION/DRIVER INFO > Combination MeterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.3. Release the screws, clips and claws, and remove the visor - com ...
Dtc u0100 lost communication with ecm/pcm a
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from the engine control module (ECM) does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Proc ...
Operation
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. READ CURRENT DATA1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input t ...
