Subaru Crosstrek Service Manual: Installation

1. Install the CVTF cooler (with warmer feature) to the transmission.

Tightening torque:

23 N·m (2.3 kgf-m, 17.0 ft-lb)

2. Install the engine coolant inlet hose.

NOTE:

With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.

3. Install the CVTF inlet hose and CVTF outlet hose to transmission.

NOTE:

Use the new CVTF inlet hose and CVTF outlet hose.

4. Connect the engine coolant outlet hose.

5. Check installation condition of each hose.

• Make sure the hoses do not interfere with each other or with other components.

• Check each hose for bent, excess curve, and twisting conditions.

6. Install the engine hanger rear.

Tightening torque:

21 N·m (2.1 kgf-m, 15.5 ft-lb)

7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.

8. Connect the engine harness connectors, then install the harness connector bracket.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">

10. Connect the battery ground terminal.

11. Fill engine coolant. Engine Coolant > REPLACEMENT">

12. Adjust the CVTF level. CVTF > ADJUSTMENT">

Inspection

Cvtf filter

Other materials:

Installation
IGNITION(H4DO) > Spark PlugINSTALLATION1. RH SIDEInstall in the reverse order of removal.CAUTION:Degrease the ignition coil installation portion and the mounting bolts.Tightening torque:Spark plug17.5 N·m (1.8 kgf-m, 12.9 ft-lb)Ignition coil8.5 N·m (0.9 kgf-m, 6.3 ft-lb)2. LH SIDEIn ...

Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyDISASSEMBLYNOTE:Attach a cloth to the end of driven shaft (on the frictional side of the thrust needle bearing) to prevent damage during disassembly or reassembly.1. Flatten the tab of the lock nut. Remove the lock nut with ST ...

Sliding moonroof
Open Close To open: Press and hold the rear side of the "OPEN/CLOSE" switch. The sun shade will also be opened together with the moonroof. The moonroof will stop at a position approximately 1.6 in (4 cm) away from the fully opened position. Press and hold the rear side of the swit ...