CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)
INSTALLATION
1. Install the CVTF cooler (with warmer feature) to the transmission.
Tightening torque:
23 N·m (2.3 kgf-m, 17.0 ft-lb)
2. Install the engine coolant inlet hose.
NOTE:
With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.
3. Install the CVTF inlet hose and CVTF outlet hose to transmission.
NOTE:
Use the new CVTF inlet hose and CVTF outlet hose.
4. Connect the engine coolant outlet hose.
5. Check installation condition of each hose.
• Make sure the hoses do not interfere with each other or with other components.
• Check each hose for bent, excess curve, and twisting conditions.
(A) | CVTF cooler inlet hose |
(B) | CVTF cooler outlet hose |
(C) | Engine coolant outlet hose |
(D) | Engine coolant inlet hose |
6. Install the engine hanger rear.
Tightening torque:
21 N·m (2.1 kgf-m, 15.5 ft-lb)
7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.
8. Connect the engine harness connectors, then install the harness connector bracket.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">
10. Connect the battery ground terminal.
11. Fill engine coolant. Engine Coolant > REPLACEMENT">
12. Adjust the CVTF level. CVTF > ADJUSTMENT">
Fuel filler lid and cap
Locations of the fuel filler lid and
the lid release lever
Fuel filler lid
Fuel filler lid release lever
Refueling
Only one person should be involved in
refueling. Do not allow others to approach
the area of the vehicle near the fuel filler
pipe while refueling is in progress.
Be ...
Assembly
SEATS > Rear SeatASSEMBLYCAUTION:• Do not reuse hog rings.• Secure the hog ring using hog ring pliers.• Install the hog rings to the specified points securely and make sure that there is no wrinkle or twisting on the cover COMPL - rear backrest.1. Assemble the cover COMPL - rear ...
Lock/unlock
The rear gate can be locked and unlocked
using any of the following systems
Power door locking switch: Refer to
"Power door locking switches" 2-8.
Keyless access with the push-button
start system (if equipped): Refer to "Keyless
access with push-button start system"
2-9.
...