Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)

INSTALLATION

1. Install the CVTF cooler (with warmer feature) to the transmission.

Tightening torque:

23 N·m (2.3 kgf-m, 17.0 ft-lb)

2. Install the engine coolant inlet hose.

NOTE:

With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.

3. Install the CVTF inlet hose and CVTF outlet hose to transmission.

NOTE:

Use the new CVTF inlet hose and CVTF outlet hose.

4. Connect the engine coolant outlet hose.

5. Check installation condition of each hose.

Make sure the hoses do not interfere with each other or with other components.

Check each hose for bent, excess curve, and twisting conditions.

(A)

CVTF cooler inlet hose

(B)

CVTF cooler outlet hose

(C)

Engine coolant outlet hose

(D)

Engine coolant inlet hose

6. Install the engine hanger rear.

Tightening torque:

21 N·m (2.1 kgf-m, 15.5 ft-lb)

7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.

8. Connect the engine harness connectors, then install the harness connector bracket.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">

10. Connect the battery ground terminal.

11. Fill engine coolant. Engine Coolant > REPLACEMENT">

12. Adjust the CVTF level. CVTF > ADJUSTMENT">

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check tha ...

Cvtf filter
...

Other materials:

Malfunction indicator light does not go off
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT GO OFFTROUBLE SYMPTOM:Although malfunction indicator light comes on when the engine runs, DTC is not shown on the Subaru Select Monitor or general scan tool display.STEPCHECKYESNO1.CHECK DTC.Is DTC of eng ...

Location
ENTERTAINMENT > General DescriptionLOCATION1. AUDIO AND NAVIGATION SYSTEM(1)Telematics sub antenna(3)Speaker ASSY - tweeter front LH(5)Data communication module(2)GPS antenna ASSY(4)Audio ASSY or navigation ASSY(6)Speaker ASSY - tweeter front RH*1: Model with telematics(1)Telematics antenna(4)Fro ...

Inspection
LAN SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTION1. INSPECTION WITHOUT USING CAN DIAGNOSTICBefore performing diagnosis, check the following items that might affect troubles of each module.1. Check the battery. Battery > INSPECTION">2. Check the fuse condition.Make sure that amp ...

© 2016-2024 Copyright www.sucross.com