Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)

INSTALLATION

1. Install the CVTF cooler (with warmer feature) to the transmission.

Tightening torque:

23 N·m (2.3 kgf-m, 17.0 ft-lb)

2. Install the engine coolant inlet hose.

NOTE:

With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.

3. Install the CVTF inlet hose and CVTF outlet hose to transmission.

NOTE:

Use the new CVTF inlet hose and CVTF outlet hose.

4. Connect the engine coolant outlet hose.

5. Check installation condition of each hose.

Make sure the hoses do not interfere with each other or with other components.

Check each hose for bent, excess curve, and twisting conditions.

(A)

CVTF cooler inlet hose

(B)

CVTF cooler outlet hose

(C)

Engine coolant outlet hose

(D)

Engine coolant inlet hose

6. Install the engine hanger rear.

Tightening torque:

21 N·m (2.1 kgf-m, 15.5 ft-lb)

7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.

8. Connect the engine harness connectors, then install the harness connector bracket.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">

10. Connect the battery ground terminal.

11. Fill engine coolant. Engine Coolant > REPLACEMENT">

12. Adjust the CVTF level. CVTF > ADJUSTMENT">

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check tha ...

Cvtf filter
...

Other materials:

Driving tips
Do not drive with your foot resting on the clutch pedal and do not use the clutch to hold your vehicle at a standstill on an upgrade. Either of those actions may cause clutch damage. Do not drive with your hand resting on the shift lever. This may cause wear on the transmission components. ...

Selection of manual mode
With the vehicle either moving or stationary, move the select lever from the "D" position to the "M" position to select the manual mode. Type A Upshift indicator Downshift indicator Gear position indicator Type B Upshift indicator Downshift indicator Gear position indi ...

Dtc c1422 vdc interruption for engine convenience
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1422 VDC INTERRUPTION FOR ENGINE CONVENIENCEDTC DETECTING CONDITION:ECM prohibits the cooperation control.TROUBLE SYMPTOM:VDC does not operate.NOTE:• For the diagnostic procedure, refe ...

© 2016-2024 Copyright www.sucross.com