Subaru Crosstrek Service Manual: Clutch fluid air bleeding Procedure
CLUTCH SYSTEM > Clutch Fluid Air Bleeding
PROCEDURE
CAUTION:
Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.
NOTE:
Bleed air from the oil line with help of a co-worker.
1. Remove the clip (A) from the air intake boot.
2. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).
3. Loosen the clamp (C) which connects the air intake boot and throttle body.
4. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.
5. Fit one end of a vinyl tube into the air bleeder of the operating cylinder, and put the other end into a container.
(A) | Clutch hose |
(B) | Air bleeder |
6. Slowly depress the clutch pedal and keep it depressed. Then open the air bleeder to discharge air together with the brake fluid.
Release the air bleeder for 1 or 2 seconds. Next, close the air bleeder, and slowly release the clutch pedal.
CAUTION:
Cover the air bleeder with cloth to prevent brake fluid from being splashed on surrounding parts when loosening the bleeder.
(A) | Operating cylinder |
(B) | Vinyl tube |
7. Repeat procedure 6), until there are no more air bubbles appearing from the air bleeder.
8. Tighten the air bleeder.
Tightening torque:
T: 7.8 N·m (0.8 kgf-m, 5.8 ft-lb)
9. After stepping on the clutch pedal, make sure that there are no leaks evident in the entire clutch system.
10. After bleeding the air from clutch system, ensure that the clutch operates properly.
11. Install the air intake boot. Air Intake Boot > INSTALLATION">
Installation
CLUTCH SYSTEM > Release Bearing and LeverINSTALLATIONNOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Conta ...
General diagnostic table Inspection
CLUTCH SYSTEM > General Diagnostic TableINSPECTION1. CLUTCHSymptomsPossible causeCorrective action1. Clutch slippageIt is hard to perceive clutch slippage in the early stage, but pay attention to t ...
Other materials:
Defogger setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Defogger" item. Then push the
button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Select ...
Fuel pressure Inspection
MECHANICAL(H4DO) > Fuel PressureINSPECTION1. Release the fuel pressure. Fuel > PROCEDURE">2. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to release the inner pressure of the fuel tank.3. Disconnect the fuel delivery tube from the fuel delive ...
Replacement
PERIODIC MAINTENANCE SERVICES > Front & Rear Differential Gear OilREPLACEMENT1. FRONT DIFFERENTIAL (MT MODEL)Front differential gear oil of MT model lubricates the transmission and differential together. Refer to “5MT” section for replacement procedure. Transmission Gear Oil > ...
