Subaru Crosstrek Service Manual: Basic diagnostic procedure Procedure
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Basic Diagnostic Procedure
PROCEDURE
NOTE:
When the sunload sensor check is performed indoors or in the shade, it could be diagnosed as sensor having an open circuit. Always perform the inspection in direct sunlight.
| STEP | CHECK | YES | NO |
1.START INSPECTIONS.
1) Prepare the tools. General Description > PREPARATION TOOL">
2) Perform the pre-inspection. General Description > INSPECTION">
Is any malfunction found in pre-inspection?
Fix the malfunction found in pre-inspection, and go to the next inspection step. Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.
2.CHECK DTC.
1) Under the failure condition, leave the vehicle for one minute or more.
2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">
NOTE:
• If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. Diagnostic Procedure for Subaru Select Monitor Communication > COMMUNICATION FOR INITIALIZING IMPOSSIBLE">
• Record the time stamp and the freeze frame data recorded together with the DTC. For time stamp, refer to “LAN SYSTEM”. General Description > CAUTION">
Is DTC displayed?
List of Diagnostic Trouble Code (DTC) > LIST">
Refer to Diagnostics with Phenomenon. Diagnostics with Phenomenon > INSPECTION">
Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Read Current DataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select  ...
Clear memory mode Operation
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select  ...
Other materials:
Operation
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlOPERATION1. While the VDC sequence control is performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve is operated.2. VDC sequence control can be started by S ...
Type D
Temperature control dial (Refer to "Automatic
climate control operation (type B, C
and D)" F4-7 and/or "Temperature control
Defroster button (Refer to "Airflow mode
selection"
Rear window defogger button (Refer to
"Defogger and deicer"
DUAL mode button (Refer to ""DUAL"
mode ( ...
Installation
SECURITY AND LOCKS > Steering Lock CMINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type D” described in “REGISTRATION MANUAL FOR ...
