Subaru Crosstrek Owners Manual: Head restraint height adjustment
- Head restraint
- Release button
To raise: Pull the head restraint up.
To lower: Push the head restraint down while pressing the release button on the top of the seatback.
To remove: While pressing the release button, pull out the head restraint.
To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. Press and hold the release button to lower the head restraint.
Each head restraint should be adjusted so that the center of the head restraint is closest to the top of the occupant's ears.
NOTE
When the head restraint cannot be pulled out or installed due to insufficient clearance between the head restraint and the roof, tilt the seat and then perform the installation and removal tasks.
Head restraint adjustment
WARNING
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the
risk of serious neck injury in the
event that the vehicle is struck
from the rear ...
Head restraint angle adjustment
The angle of the head restraint can be
adjusted in several steps. While maintaining
a suitable driving posture, adjust the
head restraint to a position where the back
of your head is as close ...
Other materials:
List of diagnostic trouble code (dtc) List
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LIST• Models without EyeSightDTCItemContent of diagnosisReferenceC1211FRONT RIGHT ABS SENSOR CIRCUITOpen/high input of front ABS wheel speed sensor RH Diagnostic Procedure with Diagnostic Trouble Code (DTC) ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Mounting SystemINSTALLATION1. PITCHING STOPPER1. Install the pitching stopper.Tightening torque:T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)2. Install the air intake boot assembly. Air Intake Boot > ...
Caution
POWER ASSISTED SYSTEM (POWER STEERING) > General DescriptionCAUTION• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary re ...
