Subaru Crosstrek Service Manual: Disassembly
CONTROL SYSTEMS > MT Gear Shift Lever
DISASSEMBLY
1. Remove the lock wires.
(A) | Lock wire |
2. Remove the rod from gear shift lever.
(A) | Rod |
(B) | Lever |
(C) | Stay |
3. Separate the rod and inner boot.
4. Remove the snap ring from the stay.
(A) | Snap ring |
5. Separate the gear shift lever and the stay.
6. Remove the boot and bushing from the gear shift lever.
(A) | O-ring |
(B) | Bushing |
7. Remove the spring pin, and then remove the bushing and snap ring.
(A) | Spring pin |
(B) | Bushing |
(C) | Snap ring |
8. Remove the boss from the joint.
9. Remove the bushing and spacer from the boss.
(A) | Bushing |
(B) | Spacer |
10. Remove the bushing and cushion rubber from the stay.
(A) | Bushing B |
(B) | Stay |
(C) | Cushion rubber |
Removal
CONTROL SYSTEMS > MT Gear Shift LeverREMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.2. Rem ...
Inspection
CONTROL SYSTEMS > MT Gear Shift LeverINSPECTION1. Check the parts (bushing, cushion rubber, spacer, boot, stay and rod, etc.) for deformation, damage and wear. If necessary, correct or replace faul ...
Other materials:
Dtc c1732 lateral g sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1732 LATERAL G SENSORDTC detecting condition:Defective lateral G sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.ST ...
Dtc b1660 passenger s airbag on indicator failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1660 PASSENGER’S AIRBAG ON INDICATOR FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Passenger’s airbag indicator is faulty.• Airbag control module is faulty.&b ...
Removal
LIGHTING SYSTEM > Day Time Running ResistorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the screw and clips, and turn over the front side of the mud guard - front.4. Remove the resistor assembly - daytime running light.CAUTION:The resistor ma ...
