Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Inspection

BRAKE > Brake Pipe

INSPECTION

Check the pipe for crack and damage, and also check the connection for fluid leakage. If any faulty is found, repair or replace the relevant part.

NOTE:

Use a mirror when inspecting back sides and other locations which are hard to see.

Brake pipe
...

Removal
BRAKE > Brake PipeREMOVALCAUTION:• Be careful of the following items. Failure to do so may cause the airbag system malfunction.– Yellow connectors and harnesses with yellow tapes around th ...

Other materials:

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...

Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorINSPECTION1. CHECK WITH SUBARU SELECT MONITOR1. Connect the Subaru Select Monitor.NOTE:For detailed operation procedures, refer to “Application help”.(1) On «Start» display, select «Diagnosis».(2) On «Vehicle selection» ...

ECO gauge (if equipped)
U.S.-spec. models Except U.S.-spec. models The ECO gauge shows the difference between the current rate of fuel consumption and the average rate of fuel consumption since the trip meter was last reset. If the needle of the gauge moves towards the right side, this indicates better f ...

© 2016-2021 Copyright www.sucross.com