Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: General description

CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Learning Control

GENERAL DESCRIPTION

Follow the messages displayed on the Subaru Select Monitor when working.

When the following work is performed, perform learning work for the transmission.

Replacement of TCM/Replacement or disassembly of transmission assembly/Replacement of control valve body/Clearing AT leaning value is executed.

Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Learning ControlPROCEDURE1. PREPARATION FOR LEARNING1. Warm up or cool down until the ATF temperature displayed on the Subaru Select Monitor is 40 ...

Transmission control module (tcm) i/o signal
...

Other materials:

Installation
SECURITY AND LOCKS > Impact SensorINSTALLATION1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. In ...

Hill start assist system
Ensure that the Hill start assist system operates properly under the following circumstances. 1. Stop the vehicle on an uphill grade by depressing the brake pedal (all models) and clutch pedal (MT models only), with the engine running. 2. Make sure that the vehicle does not move backward ...

Dtc p0020 "a" camshaft position actuator control circuit/open bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0020 "A" CAMSHAFT POSITION ACTUATOR CONTROL CIRCUIT/OPEN BANK 2DTC detecting condition:Immediately at fault recognitionTrouble symptom:Improper idlingCAUTION:After servicing or replacing faulty part ...

© 2016-2021 Copyright www.sucross.com