INSTRUMENTATION/DRIVER INFO > Fuel Gauge
SPECIFICATION
Since the meter - main assembly cannot be disassembled, do not remove or inspect the fuel gauge alone. (Do not remove the cover on the back surface.)
Wiring diagram
CONTROL SYSTEMS > AT Shift Lock Control SystemWIRING DIAGRAM1. MODEL WITHOUT PUSH BUTTON IGNITION SWITCH(1)Ignition switch(5)TCM (shift range information)(9)Battery(2)Stop light and brake switch(6)Key lock solenoid(10)ECM (delivery (test) mode signal)(3)Key warning switch(7)Shift lock solenoid(11 ...
Installation
CLUTCH SYSTEM > Master CylinderINSTALLATION1. Install the master cylinder to the body, and connect the clutch pipe and the tank hose.Tightening torque:T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)2. Connect the push rod of the master cylinder, and install the ...
Installation
STARTING/CHARGING SYSTEMS(H4DO) > BatteryINSTALLATIONCAUTION:After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.1. Install the battery.2. Set the battery ...