Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Entering letters and numbers/list screen operation

Subaru Crosstrek Owners Manual / Audio / Audio set / Basic information before use / Entering letters and numbers/list screen operation

Entering letters and numbers

When entering the Bluetooth device name or PIN-code, or the phone number, letters and numbers can be entered via the screen.

Entering letters and numbers

Enter letters (example: In-Car-Device setting)

  1. Enter the desired characters (alphabet key mode).
  2. Switch to the screen for characters.
  3. Enter a space.
  4. Confirm the characters/numbers entered into the window.
  5. Delete a character/number entered into the window.

List screen

Multimedia playlists (example: iPod playlist)
Multimedia playlists (example: iPod playlist)

  1. Select a category that wants to play back.
  2. Return to the playback display of each mode.
  3. Select to skip to the next or previous page.
Touch screen operation
This system is operated mainly by the keys on the screen. When a screen key is touched, a beep sounds. You can set the beep sound. Refer to "Unit settings" NOTE If the system does not res ...

Initial screen
When the ignition switch is in the "ACC" or "ON" position, the initial screen will be displayed and the system will begin operating. When using the SUBARU STARLINK function (if equipped), ...

Other materials:

Removal
EXTERIOR/INTERIOR TRIM > Glove BoxREMOVALNOTE:Refer to “Security and Locks” section for key cylinder replacement. Key Lock Cylinders > REPLACEMENT">1. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remove the damper COMPL - pocket ...

Installation
AIRBAG SYSTEM > Roll ConnectorINSTALLATIONCAUTION:If the steering wheel and steering angle sensor (steering roll connector) are removed, be sure to perform the following operations.• Align the center position of the steering roll connector.• Perform the neutral position setting of the ...

Installation
DRIVE SHAFT SYSTEM > Front AxleINSTALLATION1. Install the front drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the hub spline, and pull it into the specified position.(2) Tighten the ax ...

© 2016-2020 Copyright www.sucross.com