Subaru Crosstrek Service Manual: Dtc b1402 immobilizer key collation
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B1402 IMMOBILIZER KEY COLLATION
DTC DETECTING CONDITION:
• Incorrect immobilizer key (use of unregistered key in body integrated unit)
• Faulty antenna
• Communication failure between key and body integrated unit
| STEP | CHECK | YES | NO |
1.CHECK DTC.
Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">
Is any of DTC B1410 or B1411 detected?
Perform the diagnosis according to the DTC.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1575 INCORRECT IMMOBILIZER KEY">
Dtc b1571 reference code incompatibility (immobilizer cm to ecm)
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1571 REFERENCE CODE INCOMPATIBILITY (IMMOBILIZER CM TO ECM)DTC DETECTING CONDITION:Reference code incompatibi ...
Dtc b1405 scu collation
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1405 SCU COLLATIONDTC DETECTING CONDITION:Reference code incompatibility between security control module and ...
Other materials:
Disabling functions
By operating the access key
If you have registered a PIN code for PIN
Code Access, you can disable the keyless
access function by operating the access
key. For details about registering a PIN
code, refer to "Registering a PIN code"
1. Open the driver's door.
2. Rotate the lock lever forwa ...
Dtc u0100 lost communication with ecm/pcm a
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from the engine control module (ECM) does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Proc ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorINSPECTION1. CRANKSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)1. Prepare an oscilloscope.2. Remove the glove box. Glove Box > REMOVAL">3. Connect the probe to ECM connector.Terminal No.Probe16+1−4. Start the eng ...
