Subaru Crosstrek Owners Manual: Connecting a smartphone
If you connect a smartphone to this system after starting a supported aha application on the smartphone, you can display and operate the aha application displayed on the smartphone on the system screen.
1. Run the aha application on your smartphone.
2. Connect the iPhone/iPod touch to the USB port or connect the Android device by utilizing the Bluetooth connection (SPP and A2DP profile).
-
For details about connecting an iPhone/iPod touch: Refer to "Connecting and disconnecting a USB memory/ portable device" F5-17.
-
For details about registering or con-necting an Android device: Refer to "Registering/connecting Bluetooth device" F5-65.
NOTE
When iPhone/iPod touch and Android devices are connected at the same time, iPhone/iPod touch is prioritized.
How to change the source
-
Select the "aha" key on the source select screen. Refer to "Basic operation" F5-18.
-
Select the "aha" key on the APPS screen. Refer to "SUBARU STARLINK" F5-26.
NOTE
When starting-up "aha", there are some smartphone models for which "aha" application does not start up automatically.
Before using aha application
In order to use the aha application on this
system, the application must be installed
on the smartphone.
Settings required to use aha
application
Search and download the aha application
from you ...
Using aha application
1. When the top screen is displayed,
touch the station key.
Example of the main screen
2. Select the desired station from the list.
The selected station is displayed.
NOTE
The followin ...
Other materials:
Air cleaner element
WARNING
Do not operate the engine with the
air cleaner element removed. The air
cleaner element not only filters
intake air but also stops flames if
the engine backfires. If the air
cleaner element is not installed
when the engine backfires, you
could be burned.
CAUTION
When replacing the ...
Removal
LIGHTING SYSTEM > Rear Turn Signal Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...
Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...