Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Check list for interview Check

AIRBAG SYSTEM (DIAGNOSTICS) > Check List for Interview

CHECK

Customer’s Name

Inspector’s Name

Date Vehicle Brought in

/ /

Registration No.

Odometer Reading

km

miles

V.I.N.

Date Problem Occurred

/ /

Registration Year

/ /

Weather

Fine

Cloudy

Rainy

Snowy

Others:

Temperature

°C ( °F)

Road Condition

Flat road

Uphill

Downhill

Gravel road

Others:

Vehicle Operation

Starting

Idling

Driving

Constant speed

Accelerating

Decelerating

Turning

Others:

Details of Problem

Airbag Warning Light Operation

Normal (After turning the ignition switch to ON, lit for approximately 6 seconds and goes off.)

Remains ON

Remains OFF

DTC output

OK code

DTC: (Code: )

Batch save of event record data Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Batch save of Event record dataOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and sel ...

Clear memory mode Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirme ...

Other materials:

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchINSTALLATION1. Install the thrust bearing.NOTE:Make sure to install in the right direction.2. Install the transfer clutch assembly.3. Select the transfer driven gear shim. Transfer Clutch > ADJUSTMENT">4. Attach the selected t ...

Preparation for overhaul Procedure
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Preparation for OverhaulPROCEDURE1. Clean oil, grease, dirt and dust from the transmission.2. When transmission gear oil remains in the transmission, using the TORX® bit T70, remove the drain plug, and drain the gear oil completely.3. Attach the drain ...

Dtc b2a0a red led circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0A RED LED CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:• Current in LED is less than 1 mA. (Improper LED connection, etc.)• Current is more than 200 mA for at le ...

© 2016-2024 Copyright www.sucross.com