Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Check adaptive cruise control indicator light/constant speed cruise control indicator light and cruise set indicator light

Subaru Crosstrek Service Manual / Eyesight (diagnostics) / Diagnostics with phenomenon / Check adaptive cruise control indicator light/constant speed cruise control indicator light and cruise set indicator light

EyeSight (DIAGNOSTICS) > Diagnostics with Phenomenon

CHECK ADAPTIVE CRUISE CONTROL INDICATOR LIGHT/CONSTANT SPEED CRUISE CONTROL INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT

TROUBLE SYMPTOM:

Adaptive cruise control or conventional cruise control can be set, but adaptive cruise control indicator light/constant speed cruise control indicator light and cruise SET indicator light do not illuminate.

STEPCHECKYESNO

1.CHECK ADAPTIVE CRUISE CONTROL INDICATOR LIGHT/CONSTANT SPEED CRUISE CONTROL INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT.

Check the combination meter. System Operation Check Mode > OPERATION">

Does adaptive cruise control indicator light/constant speed cruise control indicator light and cruise SET indicator light illuminate?

Diagnostics with Phenomenon > CHECK ADAPTIVE CRUISE CONTROL INDICATOR LIGHT/CONSTANT SPEED CRUISE CONTROL INDICATOR LIGHT AND CRUISE SET INDICATOR LIGHT">Go to Step 2.

Replace the meter case assembly.
Combination Meter">

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure">

Is there any fault?

Perform the diagnosis according to diagnosis for LAN system.

Replace the stereo camera. Stereo Camera > REMOVAL">

Diagnostic procedure with phenomenon
EyeSight (DIAGNOSTICS) > Diagnostics with PhenomenonDIAGNOSTIC PROCEDURE WITH PHENOMENON1. TEMPORARY STOP OF EyeSightPhenomenonCheck ItemReference1Temporary stop occurs frequently.EyeSight temporar ...

Ecm cancel code(s) display
...

Other materials:

Menu screens
Pull the " /SET" switch to enter the menu screens when all of the following conditions are satisfied. The vehicle has been completely stopped. The select lever is in the "P" position. The menu screen entering screen is selected. The "  " information reminder is off. Th ...

Dtc u0073 control module communication bus off
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDTC DETECTING CONDITION:Integrated unit communication is shut down because of high speed CAN error.TROUBLE SYMPTOM:CAN communication is not normal.STEPCHECKYESNO1.CHECK ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSTALLATION1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.• Apply NICHIMOLY N-130 or the equivale ...

© 2016-2024 Copyright www.sucross.com