Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: CD player and disc

WARNING

CD players use an invisible laser beam which could cause hazardous radiation exposure if directed outside the unit. Be sure to operate the player correctly.

Use only discs marked as shown above. The following products may not be playable on your player:

Special shaped discs
Special shaped discs

Transparent/translucent discs
Transparent/translucent discs

Low quality discs
Low quality discs

Labeled discs
Labeled discs

CAUTION

CD player and disc

  1. Correct
  2. Wrong

CD player and disc

To clean a disc: Wipe it with a soft, lintfree cloth that has been dampened with water. Wipe in a straight line from the center to the edge of the disc (not in circles). Dry it with another soft, lint-free cloth. Do not use a conventional record cleaner or anti-static device.

CD-R/RW discs

USB memory device

iPod

The following iPod, iPod nano, iPod classic, iPod touch and iPhone devices can be used with this system.

Made for

*: iPod video not supported

Depending on differences between models or software versions etc., some models might be incompatible with this system.

Radio
Usually, a problem with radio reception does not mean there is a problem with the radio - it is just the normal result of conditions outside the vehicle. For example, nearby buildings and terrai ...

File information
Compatible compressed files (Audio) Corresponding sampling frequency (Audio) Corresponding bit rates (Audio) (Variable Bit Rate (VBR) compatible) MP3 (MPEG Audio Layer 3), WMA (Wi ...

Other materials:

Dtc p0116 engine coolant temperature sensor 1 circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0116 ENGINE COOLANT TEMPERATURE SENSOR 1 CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start• Improper id ...

Inspection
LIGHTING SYSTEM > Hazard SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply battery voltage between the connector terminals to check the lighting ...

Monitor (if equipped)
To clean the audio/navigation/multi function display monitor, wipe it with a silicone cloth or with a soft cloth. If the monitor is extremely dirty, clean it with a soft cloth moistened with neutral detergent then carefully wipe off any remaining detergent. CAUTION Do not spray neutral det ...

© 2016-2020 Copyright www.sucross.com