Subaru Crosstrek Owners Manual: Casual speech recognization
Due to natural language speech recognition technology, this system enables recognition of a command when spoken naturally. However, the system cannot recognize every variation of each command.
In some situations, it is possible to omit the command for the procedure and directly state the desired operation. Not all voice commands are displayed in the function menu.
NOTE
If the command cannot be recognized completely, the command input screen will be displayed. (Search results will be shown based on the part of the command that was recognized.)
Expression examples for each function
|
Command |
Command Expression examples |
| "Dial <phone number>" | Phone <phone number>. |
Voice command example: Dial
number
1. Press the talk switch on the steering
wheel.
2. Say "Dial number".
3. Say "Dial <number>".
For example, if the phone number is
2345678:
Say "two three four five six seven
eight"
...
Command list
Recognizable voice commands and their
actions are shown below.
NOTE
Some voice commands may not be
available depending on the market,
vehicle specifications or the device
connection status ...
Other materials:
Component
PARKING BRAKE > General DescriptionCOMPONENT1. PARKING BRAKE (REAR DISC BRAKE)(1)Back plate - rear brake(7)Spring - secondary shoe return(13)Cup - shoe hold-down(2)Retainer - rear brake(8)Spring - strut(14)Parking brake shoe (primary)(3)Spring washer - rear brake(9)Strut - brake(15)Pin - primary ...
Dtc p0198 engine oil temperature sensor "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0198 ENGINE OIL TEMPERATURE SENSOR "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Hard to start• Improper idling• Poor driving performanc ...
Inspection
GLASS/WINDOWS/MIRRORS > Remote Control Mirror SwitchINSPECTION1. Disconnect the connector of the switch - door mirror.2. Check the resistance between switch - door mirror terminals.Preparation tool:Circuit tester• Changeover switch RHTerminal No.Inspection conditionsStandard — OFF1 M? or ...