Subaru Crosstrek Owners Manual: After driving
- Always check your brakes for effectiveness immediately after driving in sand, mud or water. Do this by driving slowly and stepping on the brake pedal. Repeat that process several times to dry out the brake discs and brake pads.
- After driving through tall grass, mud, rocks, sand, rivers, etc., check that there is no grass, bush, paper, rags, stones, sand, etc. adhering to or trapped on the underbody. Clear off any such matter from the underbody. If the vehicle is used with these materials trapped or adhering to the underbody, a mechanical breakdown or fire could occur.
- Wash the vehicle's underbody after offroad driving. Suspension components are particularly prone to dirt buildup, so they need to be washed thoroughly.
During driving
General precautions:
Drive carefully. Do not take unnecessary
risks by driving in dangerous areas or
over rough terrain.
Slow down and employ extra caution at
all times. When driving off-r ...
Winter driving
...
Other materials:
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...
Bulkhead wiring harness (in engine compartment) Location
WIRING SYSTEM > Bulkhead Wiring Harness (In Engine Compartment)LOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionB35BlackB-2 Mass air flow and intake air temperature sensorB62Light grayC-3 Front ABS wheel speed sensor RHB85Light grayB-5 Front wiper motorB104Light grayC-4 Pressure switch ...
Installation
EXTERIOR BODY PANELS > Rear DoorINSTALLATION1. REAR DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - rear door on it.2. Apply grease to the moving part of door hinges.3. Adjust the height by the jack, and temporarily install the panel assembly - rear door to the upper hing ...