Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Adding the windshield washer fluid

CAUTION

Never use engine coolant as washer fluid because it could cause paint damage.

Adding the windshield washer fluid

Remove the washer tank filler cap, then add windshield washer fluid until it reaches the "FULL" mark on the tank.

Windshield washer fluid
Windshield washer fluid warning light (type A) Windshield washer fluid warning light (type B) When there is only a small amount of washer fluid remaining, the windshield washer fluid warni ...

Windshield washer fluid
Use windshield washer fluid. If windshield washer fluid is unavailable use clean water. In areas where water freezes in winter, use an anti-freeze type windshield washer fluid. SUBARU Windshiel ...

Other materials:

Dtc b2327 rear radar internal failure (internal electric circuit)
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2327 REAR RADAR INTERNAL FAILURE (INTERNAL ELECTRIC CIRCUIT)DTC DETECTING CONDITION:Defective radar sensorTROUBLE SYMPTOM:• All functions of BSD/RCTA stop.• Fail i ...

Intake manifold vacuum Inspection
MECHANICAL(H4DO) > Intake Manifold VacuumINSPECTION1. Turn the ignition switch to OFF.2. Warm up the engine.3. Install the vacuum gauge.(1) Remove the brake booster vacuum hose from the intake manifold.(2) Connect the vacuum gauge to the intake manifold.4. Keep the engine at idle speed and read t ...

To increase the speed (by accelerator pedal)
1. Depress the accelerator pedal to accelerate the vehicle to the desired speed. 2. Press the "RES/SET" switch to the "SET" side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal. NOTE U.S.-spec. models If t ...

© 2016-2019 Copyright www.sucross.com